Power your Radio Install Backup Batteries Use the Antenna. Basic Operation. Set the Clock Set the Alarm When the Alarm Sounds Using the Radio Set Radio Station Memory Using the Weather Radio Set Weather Channel Memory. Viewing Weather Alerts Receiving Alerts for Specific Areas Using Skywarn Advanced Operation.
Changing Radio Settings. Connecting an External Alert Restoring Factory Default Settings Additional Information NWS Alert Descriptions Service and Repair. FCC Information Limited Warranty Its center tip must be set to positive and its plug must fit the DC 12V jack.
Using an adapter that does not meet these specifications could damage the radio or adapter. The main unit should be located indoors, but the remote sensor can be placed either indoors or out.
The construction of your home or office might affect the transmission range between the main unit and the remote sensor.
If you have a choice of several locations, try each to see which provides the best performance. Only the remote sensor is weatherresistant. Mounting the Main Unit To set the main unit on a flat surface, pull the built-in stand away from the back of the unit. Drill a hole in the wall at the desired mounting location. Position the keyhole slot over the screw and slide the thermometer down to secure it.
Features 15 1. Align the keyhole slots on the mounting bracket with the screws and slide the bracket downward to secure it. Slide the remote sensor into the mounting bracket as shown. Additional remote sensors Cat. To display the temperature and humidity information for a specific remote sensor, repeatedly press CHANNEL on the main unit until the desired channel number appears. Operation 19 Note: If the main unit does not receive or stops receiving a signal from the remote sensor, appears.
The readings from each channel appear for about 4 seconds. To stop scanning, press any button. When the temperature returns to within the measurement range, the display returns to normal. An indicator appears to show the comfort level. If there are no arcs above the channel number, then the main unit is not receiving a signal. The display Operation 25 resets and the current temperatures appear. When a remote sensor records a temperature or humidity reading that matches one you set, the main unit sounds an alarm for about 1 minute, the main unit displays the information for channel 1, and HI or LO and the temperature or hu- 26 Operation midity flash.
To silence the alarm sooner, press any button on the main unit. If a channel other than channel 1 is selected when the alarm sounds, the display switches to channel 1 and the readings flash. The alarm sounds for about 1 minute. The alarm sounds again if the current reading falls below the set limit, then meets or exceeds the set limit again. Note: If the main unit detects another set limit, the alarm continues to sound for about 1 more minute.
Quick Links. See also: Owner's Manual. Table of Contents. Previous Page. Next Page. You can hang the main unit indoors on a wall or use its built-in stand for easy viewing on a table.
You can place the remote sensor outdoors or in an- other room to monitor the temperature at that loca- tion. Page 4 the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the follow- ing measures Page 5: Fcc Declaration Of Conformity 1 this device may not cause harmful in- terference, and 2 this device must accept any interference received, including interfer- ence that may cause undesired operation.
Page 6 longest life, we recommend RadioShack alkaline bat- teries. Warning: Dispose of old batteries promptly and prop- erly. Do not burn or bury them. Page 8: In The Main Unit 3.
0コメント